This will back feed all the other tv s. Using either a coaxial rf cable fig 1 or composite audio video a v cable fig 2 to connect the tv2 output of the receiver to the tv.
If using a composite a v cable turn on the tv and press the tv video or input button to select the appropriate video input then begin using the receiver.
How to get second tv working with dish network. I disconnected the tv and emptied out the room so i could remodel. I have dish network and i can t get tv 2 to work with my 722k duo dvd receiver it was working before. In order to install a second dish you must run a direct line either from the dish itself or from a specialized satellite splitter that you can only get from dish network.
If you do you can run your satellite output to your satellite box then run satellite out back into the coax cable connection. So i know that the second tv was at one point working and we know that the physical cable that is running into our bedroom is good. I hooked up a different tv instead of the one that was in the room and now i can t get into work.
Plug the two remaining hdmi cables into the hdmi out ports on the other side of the hdmi splitter. The main pieces of equipment for setting up a second tv on a dish dual tuner receiver include a coaxial cable and an additional remote control. Turn your new tv on either by directly pressing the power button on the tv itself or using the tv specific remote not the dish network remote since that s clearly not possible yet.
How to display hd on two tvs with a dish receiver plug one of the hdmi cables into the hdmi port on the back of the hd satellite receiver. Geting tv signal to second tv from one dish receiver do you have two outputs on the jack for your main tv. While installing a second television onto a cable line is fairly simple work satellite dishes are more difficult.
When we switched to dish network we got the vip211k for our bedroom and the 722k for the basement with the second tv going to my daughter s tv. Route each coaxial cable from the individual tv to. Connect the other end of the hdmi cable into the in port on the hdmi splitter.
On the dish network remote control press and hold the tv mode button for three seconds until all the mode buttons light up.