Your stereo receiver is going into protection mode because the receiver has an internal short a speaker is bad or the speaker wiring has a problem such as incorrect wire gauge or bad connections. My kenwood amp is in protection mode.
Reset button is not fixing problem.
How to get my kenwood out of protect mode. If you can t turn your amp s power light on even by pressing the button you might be in protect mode. I tried disconnecting the speaker wires but that made no difference. These amps indicate protect mode by blinking the power light before shutting down completely.
If you ve done all the troubleshooting you know how to do and the problem still hasn t gone away it s time to get professional help. Most of the time it ll be one of the problems with your installation that keeps your kenwood in protection mode but it can also be caused by a failure in the receiver itself. My cb radio puts out 35 watts in my truck and triggers my stereo to protect mode.
None of the fuses were burnt out. My kenwood kdc mp335 is on protect mode but its not blinking. Most of the time when u have a your stereo go in protect mode with no extra amplifiers and what not you have a grounded speaker wite that touches metal and shorts the circuit try to find out which wire.
Kenwood equips its receivers with a protection mode to safeguard them. Turn your key to acc mode and then back off to see if it resets it. Amps go into protect mode for many reasons.
I just replaced the fuse box in the line with a brand new fuse. Its happen before ex read more. The light goes on when first powered up but then shut off.
You have to do a hard reset and unplug it entirely. Here are a few of the most common. Causes of power protect mode.
Neither the on the amp or in the line before or after replacement.