This same procedure should work for similar items that are mounted to drywall. Remove the old or broken towel bar from your wall.
Unscrew the screws and take the part off the wall.
How to get a towel rack off the wall. And you should find out what. It s important to sand and. You ll need a hex wrench or mini screwdriver to loosen the setscrew.
Or check out some of these top selling towel barsfor an upgrade. If you ve done some damage in this process you can pick up a set of replacement mounting brackets here. Use a cordless drill and make the existing holes in the wall larger so you can put in toggle bolts.
Grab each end of the towel bar and lift it straight up to remove the towel bar from the mounting plates. Loosen and remove the setscrews with a phillips screwdriver or hex wrench depending on the screw head. How to hang a towel rack begins first by removing the loose end posts.
To repair a loose or broken towel bar. Even if the towel bar isn t mounted on the wall by screws it was mounted by something. Put the toggle bolts on the towel bar mounting hardware by sliding the screw into the mounting hole and threading the spring loaded piece onto the other side.
This is how to remove a towel rack from drywall. Although you can do this with an oscillating tool it s safer to do it manually with a putty knife and a hammer to minimize damage to the wall tiles. The sooner you find out what was used to mount the towel bar to the wall the easier it will be to remove it from the wall.
If one post is rock solid leave it in place chances are it s fastened to a wall stud. Then work it all around the fixture. If the steps is followed well the process should be one easy task for anyone involved.
If you don t make sure what was used you might have a hard time to get it off. Step 2 remove all containing screws next use the small phillips screwdriver and remove all the retaining screws from the wall brackets. If your towel rack is glued to the tile wall you have to break through the glue bond holding each post to the tile.
First you ll need to turn off the valves by turning them clockwise. There s a slight chance that the existing anchors are adequate but the screws have loosened. Step 3 remove the screws securing the mounting plate to the wall using the screwdriver.
Step 3 prepare your washing up bowl. Remove the old towel bar or soap dish to replace a towel bar use an oscillating tool jam the blade into a corner about 1 in.